YORKVILLE elite ES700P Manuel De L'utilisateur page 6

Yorkville
ES700P
Power Amplifier Power (internal):
Frequency response:
Input Impedance:
Speaker components:
Ring(Shaft):
The sleeves of the input are not grounded except when the input ground switch is
set to Gnd. Grounding is done through a 100-Ohm protection device in order to
Clipping, excursion and average voice coil current, thermal
Note: The ES700P built-in stand mounting adapter can be used with Yorkville SW-Teletube accessory to support
our E160 cabinets. The support tube can be adjusted up to it's full 5-foot 4-inch extension safely as long as the
ES700P is not inclined mor than 10° (10-degrees).
WARNING: Larger or heavier cabinets shound not be used!
Specifications
Power Requirements
120V: 117V-120V AC 60 Hz 2.5A
230V: 230VAC 50 Hz 1.3A
45 Hz to 125 Hz
80 kOhms
2 x 10 inches
Input Connections
Tip: Positive (+ve)
Negative (-ve)
Grounding
prevent damage due to miswiring.
Limiting
Maximum SPL
131 dB (60 Hz to 110 Hz)
Weight
93 lb. (42 kg)
dimensions
(WxDxH): 24" x 24.5" x 17.5"
61 cm x 62.1 cm x 44.5 cm

700 Watts