Configuration - YORKVILLE elite ES700P Manuel De L'utilisateur

ES700P
POWER SUBWOOFER FULL–RANGE
AMPLIFIER SPEAKERS
Left
Left
Right
Right
ONE SUBWOOFER PER SYSTEM
T 3,15A GDC
ON POWER
T 5.0A 250V
SLO~BLO
CAUTION: REPLACE WITH
230V 120V
SAME TYPE FUSE AND RATING
50Hz 60Hz
1.3A 2.5A
ATTENTION: UTILISER UN FUSIBLE DE
LR 21877
Yorkville
RECHANGE DE MEME TYPE ET CALIBRE
CAUTION AVIS
L R
FULL–RANGE FULL–RANGE
SPEAKER SPEAKER
POWER
ES700P AMPLIFIER ES700P
SUBWOOFER SUBWOOFER
TWO SUBWOOFERS PER SYSTEM
Introduction
The ES700P is a premium quality integrated powered subwoofer and amplifier. Created
as an easy-to-setup addition to your PA, the ES700P will extend the bass of a typical
sound system with a minimum of complication, and hence is intended primarily to
operate with speaker level signals.

Configuration

The ES700P may be used in several different configurations, the minimum standard
system is one ES700P used with a pair of full range speakers. The ES700P accepts the
signal from separate Left and Right sources simultaneously. It then combines them into
one signal (to drive the internal speakers). When used in a setup where only one signal is
provided to a speaker, such as a mono system or stereo with more than one ES700P , use
either the Left or Right input.
For normal operation connect the ES700P
"INPUT LEVEL" switch should be set to "SPEAKER ." If the audio source does not have a "U" ground, i.e.: a ground pin on
the AC cord, the "INPUT GROUND" switch must be set to "GROUNDED" .The
the full range speakers. Use the left and right inputs when using a single
the left or right inputs when using separate
ES700P
does not alter the signal to the full range speakers in any way. The
power from the amplifier driving the full range speakers. Please note that an external cross-over is not necessary.
just like an ordinary speaker along with the full range speakers. The
ES700P
ES700P
ES700P
's for each side or when used in a mono system. The

POWER
Yorkville
125 Hz
HIGH
FREQUENCY
CUT OFF
ES700P
100 Hz 150 Hz
DESIGNED & MANUFACTURED BY YORKVILLE SOUND • TORONTO, CANADA
SUBWOOFER
+10
USER NOTE: LEVEL
+3
+20
This Subwoofer may be driven from Speaker Level
0
or Line Level signals. If an élite processor is used,
this Subwoofer should be plugged into the SUB
output of the processor. The High–Frequency
+30
Cutoff should be set to 150-Hz and the Input Level
should be set to LINE. For Line
-3
dB
Level operation a balanced ( Tip
Ring Sleeve ) cable should be
used. If the system is being INPUT GROUND
operated without a processor ,
UNGROUNDED
this Subwoofer can be
GROUNDED
connected to the output of the
power amplifier as shown in the INPUT LEVEL
diagrams and the Input Level
SPEAKER
should be set to SPEAKER. If
LINE
none of the equipment has a U-
ground, the INPUT GROUND
should be set to GROUNDED.
Otherwise the INPUT GROUND
I
should be set to the position that
LEFT N
best minimizes the hum.
P
(mono)
U
Refer to the Owner's
T
Manual for other modes
of operation
PARALLEL
THRU
I
RIGHT N
P
U
T
PARALLEL
THRU
may be wired before or after
in a stereo system. Use either
ES700P
will not draw any