Bis/P Lnr Key; Barring And Locking - Depaepe Telecom PREMIUM 100 Notice D'utilisation

5 - Press
6 – Repeat 2 to 5 if you want to e ase another te
7 – Replace the handset or press
- Recalling a stored number
F rom o ne-touch memory:
1 – Pick up the hands
2 – Press one of th
automatically.
From tw o-touch memory:
1 – Pick up the handset or press
2 – Press
dialled out automatically.

11 - BIS/P LNR key

For last number redial
To erase the LNR memory, after hang up, pick up the handset and keep pressed the
2 seconds, a double sharp sounds in the handset co
12 – CODE
Factory code is "0000".
If you want t o change the code proceed as follows (Phone connected and off hook):
« » «
the operation) « NNNN »(New code) «
operation)
Lost code:
Phone on hook, press and keep «
release the keys (2 sharp sounds in the handset confirms the operation) the phone is totally reset
(Memories a re erased and the phone gets back to factory settings)

13 - BARRING AND LOCKING

To activate or deactivate the barring and locking function: Phone on hook, press and keep
« » key pressed, pick up the handset, release the key and dial the 4 digits code (0000 Factory
setting).
The unlocked phone gets locked.
The locked phone gets unlocked.
When the phone is barred, no programming, no memories are possible. The keypad can be used but
only up to 4 digits.
to confirm th erasing e
r
et or press
e memory locations M1 to M10 and numbers stored will be dialled out
and one of the memory locations M11 to M20 and numbers stored will be
, pick up the handset, press
» « » « 0000 » (Old Code) (2 sharp sounds in the handset confirms
» «
lephone number from memory
or buttons
or buttons,
or buttons,
or buttons and press the
nfi rms the erasing
(2 sharp sounds in the handse
» « » keys pressed , pick up the handset and
key.
during
t confirms the
13