Westfalia Automotive 323 080 391 101 Instructions De Montage page 12

Connecting the trailer control module
13. Plug the 12-pin plug and the 18-pin plug into the trailer control module (Fig. 1/6).
14. Secure the trailer control module (Fig. 1/6) to the right-hand wheel housing using some velcro
tape.
15. Connect the black wires with the eyelet to the vehicle's ground point (Fig. 1/7).
Connecting the power supply
16. Lay the red cables on the right side along the cable harness of the vehicle up under the
dashboard and from there on through the existing cable bushing (small version, Fig. 1/10) to
the vehicle battery.
17. Let the quick-connect receptacle of the red/blue cable of the cable harness and the one of the
enclosed single red cable lock into place in the fuse holder (Fig. 3).
18. Screw the separate red cables to the positive battery terminal (Fig. 1/8).
19. Insert the fuse into the fuse holder (Fig. 1/9 and Fig. 3).
20. Repeat steps 17 – 19 with the second fuse holder.
Note: Ensure sufficient strain relief and correct installation of the fuse holder.
Special information concerning vehicles with parking distance control (PDC)
When using a trailer, the parking distance control can be deactivated by a switch located in the
centre console.
Note: The constant plus line on pin 9 of the socket is integrated into the cable set.
Checking the correct operation
21. Reconnect the negative terminal of the vehicle's battery.
22. Check the trailer function with the help of a suitable test instrument (with load resistors) or with the
help of a trailer.
23. Secure all cables using cable ties.
24. Reattach any parts removed for installation.
12 WESTFALIA Automotive GmbH
Electrical system for towing hitch
323 080 391 101 - 001 - 31/07
Installation instructions:
MINI R56