4
PROGRAMMING THE VOLTAGE TRANSFORMER (Vt)
NB: As a default setting, the network is configured for low voltage operation without a voltage transformer (NO). If you
do not want this, press
KEYS
INSTRUCTION
Press once
Press once
Press once
5
PROGRAMMING THE VOLTAGE TRANSFORMER PRIMARY (PR)
KEYS
INSTRUCTION
Press once
Press
to decrement or
Press
once to confirm value
Press
once to pass to transformer secondary programming (SE)
NB: The 6 digits correspond to the transformer primary value (400 000V maximum)
6
PROGRAMMING THE VOLTAGE TRANSFORMER SECONDARY (SE)
KEYS
INSTRUCTION
Press once
Press once
40
40
You will pass to the time integration programming (tIME 3I). If not, proceed as follows:
to increment selected digit value
DISPLAY
COMMENT
to display flashing NO
to programm the use of a Vt
Confirm a Vt.
Press on
primary programming
DISPLAY
COMMENT
Press as many times as necessary to
move to the right, or press
to the left.
DISPLAY
COMMENT
to display flashing 100
Press again for:
110
173
190
60
or
to pass to transformer
to move
SOCOMEC - Ref. : 875 510A
SOCOMEC - Ref. : 875 510A