Repair And Warranty - Megger MJ10 Guide De L'utilisateur

Repair and Warrranty
The instrument circuit contains static sensitive devices, and
care must be taken in handling the printed circuit board. If
the protection of an instrument has been impaired it should
not be used, and be sent for repair by suitably trained and
qualified personnel. The protection is likely to be impaired if, for
example, the instrument shows visible damage, fails to perform
the intended measurements, has been subjected to prolonged
storage under unfavourable conditions, or has been exposed to
severe transport stresses.
New Instruments are Guaranteed for 1 Year from the
Date of Purchase by the User.
Note: Any unauthorized prior repair or adjustment will
automatically invalidate the Warranty.
Instrument Repair and Spare Parts
For service requirements for Megger Instruments contact
Megger Limited
Archcliffe Road
Dover
Kent CT17 9EN
England
Tel: +44 (0)1304 502100
Fax: +44 (0)1304 207342
or an approved repair company.
32
or Megger
Valley Forge Corporate Center
2621 Van Buren Avenue
Norristown PA 119403
U.S.A.
Tel: +1 (610) 676-8500
Fax: +1 (610) 676-8610
Approved Repair Companies
A number of independent instrument repair companies have
been approved for repair work on most Megger instruments,
using genuine Megger spare parts. Consult the Appointed
Distributor / Agent regarding spare parts, repair facilities and
advice on the best course of action to take.
Returning an Instrument for Repair
If returning an instrument to the manufacturer for repair, it
should be sent, freight pre-paid, to the appropriate address.
A copy of the Invoice and of the packing note should be
sent simultaneously by airmail to expedite clearance through
Customs. A repair estimate showing freight return and other
charges will be submitted to the sender, if required, before work
on the instrument commences.