Water Container - Hoover DYNAMIC NEXT Manuel D'utilisation

WATER CONTAINER

The water removed from the laundry during the
drying cycle is collected in a container inside the
door of the dryer. When the container is full the
indicator on the control panel will light, and the
container MUST be emptied. However, we
recommend that the container is emptied after
each drying cycle.
NOTE: Very little water will collect during the first
few cycles of a new machine as an internal
reservoir is filled first.
To Remove the Container
1. Gently pull out the
water container holding
the handle.
When it is full the
water container will
weigh about 6 kg.
2 . T i l t t h e w a t e r
container to empty the
water out through the
spout.
When empty, replace
the water container
back as shown; first
insert the base of the
container into position
as shown then gentle
p u s h t h e t o p i n t o
position.
3. Press Button to
restart the cycle.
NOTE: If you have the
option of drainage near
to the dryer you can use
the discharge kit to
provide a permanent
drainage for the water
c o l l e c t e d i n t h e
container of the dryer.
This means that you
don't have to empty the
water container.
1
13 EN
OPERATION
1. Open the door and load the drum with
laundry. Ensure that garments do not hinder
closure of the door.
2. Gently close the door pushing it slowly until
you hear the door 'click' shut.
3. Turn the Programme Selector dial to select
the required drying programme (see
Programme Guide).
4. If drying synthetics, acrylics or delicate
items, press the
heat level.
The indicator will light up when the machine is
in low heat setting. To deselect in the first few
minutes of the programme, press the
button , after this time reset the machine to
change the setting.
5. Press the button. The dryer will start
automatically and the indicator above the
button will be continuously lit.
6. If the door is opened during the programme
to check the laundry, it is necessary to press
to recommence drying after the door has
been closed.
7. When the cycle is nearing completion the
machine will enter the cool down phase, the
clothes will be tumbled in cool air allowing the
load to cool down.
8. Following the completion of the cycle the
drum will rotate intermittently to minimize
creasing. This will continue until the machine
is switched OFF or the door is opened.
Do not open the door during the automatic
programs in order to obtain a proper drying.
button to reduce the