Package Contents - Lindy 32591 Manuel Utilisateur

Installation Manual
Introduction
Thank you for purchasing the LINDY DVI Switch Remote. This high performance switch allows
you to connect multiple DVI/HDMI devices to a single DVI/HDMI equipped TV, projector or TFT
monitor.
Designed for Home Theatre/Cinema installations, the DVI Switch Remote supports HDCP
signals and HDTV resolutions of up to 1080p. VGA analogue sources are also supported, when
used with the correct adapters. Please note, however, that there is no signal conversion from
analogue to digital or vice versa – this means the monitor has to support and auto-switch
between active analogue and digital input by itself. Switching between devices is achieved
using the push button on the switch or the supplied infra-red remote control. The remote control
is designed to allow reconfiguration of the IR codes to resolve IR conflicts with other devices.
Display
DVD Player
Typical DVI Switch Remote application (4 port model)

Package Contents

LINDY 2 or 4 Port DVI Switch Remote
Infra-red remote control with battery (CR2025)
9V DC, 500mA power supply
This manual
Features
Input Ports: 2/4 x DVI-I Female
Output Ports: 1x DVI-I Female
Device Selection: push button or infra-red remote control
4 selectable IR codes to avoid conflicts with other devices
LED channel display indicates channel selection and IR code
HDCP support
Supports HDTV resolutions of up to 1080p (1920 x 1080)
When used with computers, supports DVI-D Single Link resolutions of up to 1920 x 1200
@60Hz (TFT) and VGA resolutions of up to 2048 x 1536
English
PC
Set Top Box
- 2 -
Installation Manual
Product Information (4 port model shown)
Channel Select
Push Button
LED Indicator
Power Supply
Connection
DVI Output port
(For connecting to a
display/projector)
Channel Select
Buttons
IR Code
Select Buttons
DVI Input ports
(For connecting source
devices e.g. DVD player etc.)
Channel
Up/Down
Buttons
Battery
Compartment
Squeeze to release
- 3 -
English