Speaker Cables (25 Cm) - Panasonic TY-SP65P11WK Instructions D'installation

Installation
Mount A bracket
Rear of Plasma Display
Preparing the ends of the
speaker cables
1. Press down on the lever.
2. Insert the
cable.
3. Release the
lever.
Information for Users on Collection and Disposal of Old Equipment and used Batteries
These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries
should not be mixed with general household waste.
For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points, in accordance
with your national legislation and the Directives 2002/96/EC and 2006/66/EC.
By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential negative effects on
human health and the environment which could otherwise arise from inappropriate waste handling.
For more information about collection and recycling of old products and batteries, please contact your local municipality, your waste disposal
service or the point of sale where you purchased the items.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation.
For business users in the European Union
If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information.
[Information on Disposal in other Countries outside the European Union]
These symbols are only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for
the correct method of disposal.
Note for the battery symbol (bottom two symbol examples):
This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the Directive for the
chemical involved.
4
Mount B
bracket
Bracket mounting
screws
Remove while
twisting
1. Push down the lever.
2. Insert the
cable.
3. Return the lever to its
normal position.
4. Fasten the A and B
brackets
• Catch the B bracket claws in the A brackets
(plasma display side).
Fasten the A and B brackets with bracket
mounting screws.
• Adjust display and speaker height when
fastening the A and B brackets.
5. Connect the speaker
cables.
• After preparing the ends of the speaker
cables for the right speaker, connect them as
shown in the illustration.
• Connect the speaker cables for the left
speaker in the same way.
• The red cable is for the (+) polarity and the
black cable is for the (-) polarity. Do not
connect the cables to the wrong polarities.