Correct Use - IKA MS 3 control Mode D'emploi

• Firmly secure the accessories and vessels in place, otherwise shaking vessels
could be damaged or projected out.
• Check the appliance and accessories beforehand for damage each time you
use them. Do not use damaged components.
• Position one single shaking vessel in the centre and several shaking vessels
so that they are evenly spread out.
• Sharp edged vessels cause wear debris on the attachments.
Beware of the risk of
DANGER
- flammable materials
- glass breakage as a result of mechanical shaking
power
• Do not work with biological or microbiological media.
• Only process media that will not react dangerously to the extra energy pro-
duced through processing. This also applies to any extra energy produced
in other ways, e.g. through light irradiation.
Do not operate the appliance in explosive atmo-
DANGER
spheres, with hazardous substances or under
water.
• Safe operation is only guaranteed with the accessories described in the
"Accessories" chapter.
• Always disconnect the plug before fitting accessories.
• The appliance does not start up again automatically following a cut in the
power supply.
• The appliance may heat up when in use.
For protection of the equipment
• The voltage stated on the nameplate must correspond to the mains voltage.
• The device must only be operated with the original plug-in power supply unit.
• Protect the appliance and accessories from bumps and impacts.
• The appliance may only be opened by experts.
Unpack
Unpack
- Please unpack the device carefully
- In the case of any damage a fact report must be set immediately (post, rail
or forwarder)
Delivey scope
- MS 3 control
- Power supply
- Standard attachment MS 3.1
- Universal attachment MS 3.3
- One-hand insert MS 1.21

Correct use

Use
4 For mixing liquids
- Touch mode for single test tubes
- Continuous mode for single or several vessels
Range of use
Indoor environments similar to that a laboratory of research, teaching, trade
or industry.
The safety of the user cannot be guaranteed:
- if the device is operated with accessories that are not supplied or
recommended by the manufacturer.
- if the device is operated improperly or contrary to the manufacture's
specifications.
- if the device or the printed circuit board are modified by third parties.
- Microtiter attachment MS 3.4
- Test tube insert MS 1.32
- Operating instructions
5