Service And Maintenance; Changing The Filter Bag - Festool CTL MINI Notice D'utilisation D'origine

mobile dust extractor.

Place the mobile dust extractor in a dry room in-
accessible to unauthorised users.
9

Service and maintenance

WARNING
Risk of injury, electric shock

Always disconnect the mains plug from the
socket before performing maintenance work on
the machine!

All maintenance and repair work which requires
the motor housing to be opened must only be
carried out by an authorised service workshop.
Customer service and repair only
through manufacturer or service work-
shops: Please find the nearest address
at: www.festool.com/service
EKAT
Only use original Festool spare parts!
4
Order No. at: www.festool.com/service
5
3
2
1

Clean the level sensors [4-1] and empty the dirt
trap [1-9] regularly.
Observe the following instructions:
– The manufacturer or an instructed person must
perform a dust test at least once a year to deter-
mine whether the filter is damaged, the machine is
sealed properly and the monitoring features are
functioning correctly.
– Anything that cannot be cleaned must be discarded
in impermeable bags. Observe applicable disposal
regulations!
9.1

Changing the filter bag

NOTE
Motor damage

Never operate the extractor without a filter ele-
ment fitted as the motor may become damaged.

Open the locking clips and remove the top section
of the machine [3].

Changing the filter bag - see printing on filter bag.

Replace the top section of the machine and close
the locking clips.
 A replacement filter bag can be stored in the stor-
age compartment [2-4].
9.2 Changing the filter element

Open the locking clips and remove the top section
of the machine [3].

Turn the top section of the machine so that the fil-
ter element is facing upwards (Fig. [4]).

Fold over the handle [4-2] and remove the holder
[4-3].

Remove the used filter element [4-4] and replace
with a new one.

Dispose of the used filter element in accordance
with statutory regulations.

Replace the holder [4-3] and fold over the handle
[4-2] until it latches into place.

Replace the top section of the machine and close
the locking clips.
 The order numbers for accessories, filters and
consumables can be found in the Festool cata-
logue or on the internet at www.festool.com.
10 Environment
Do not dispose of the device in household
waste! Recycle devices, accessories and pack-
aging. Observe applicable national regulations.
EU only: In accordance with European Directive on
waste electrical and electronic equipment and imple-
mentation in national law, used electric power tools
must be collected separately and handed in for envi-
ronmentally friendly recycling.
Information on REACh: www.festool.com/reach
11 EU Declaration of Conformity
Mobile dust extractor
CTL MINI
CTL MIDI
Year of CE mark: 2013
We declare under sole responsibility that this product
complies with all the relevant requirements in the fol-
lowing directives, standards and normative documents:
2006/42/EC, 2004/108/EC (until 19.04.2016), 2014/30/EU
(from 20.04.2016), 2011/65/EU, EN 60335-1:2012, 60335-
2-69: 2009, EN 55014-1:2006+ A2:2011, EN 55014-
2:1997+ Corrigendum 1997+ A1:2001+ A2:2008, EN
61000-3-2:2006+ A1: 2009+ A2:2009, EN 61000-3-3:2013.
Festool GmbH
Wertstr. 20, D-73240 Wendlingen, Germany
Dr. Johannes Steimel
Head of Research, Development and Technical Documentation
CTL MINI/MIDI
GB
Serial no.
499590, 499591, 499592,
499593, 499594
499599, 499600, 499601,
499602, 499603
2014-10-28
13