Operating Basics - Kenwood KCA-DR300 Guide De Démarrage Rapide

Operating basics

Turning the recorder ON and OFF
Complete the installation and then connect the recorder to the car charger according to the
instructions in the previous section.
• Once the vehicle engine is started, the recorder automatically turns on. By default, the
recording will automatically start in few seconds after start-up.
• When a GPS fix is established, the GPS signal icon
screen. The number of the vertical bars in the icon indicates the strength of the signal.
• When the recorder is turned on, press the Power key to switch the LCD screen on/off.
• To manually turn the recorder on and off, press and hold the Power key for 2 seconds.
Restarting the recorder
Occasionally, you may need to perform a hardware reset when the recorder stops responding; or
appears to be "frozen" or unresponsive.
• To restart the recorder, press and hold the Power key until the system is shut down; press the
Power key again to turn the recorder on.
will show on the top-right corner of the
ENGLISH 4