Initial Start-Up; Firmware Update - AVL DITEST VCI 1000 Manuel D'utilisation

Initial Start-up

2 Initial Start-up
2.1 Adaptations
1. Plug the OBD connector (7) of AVL DiTEST VCI 1000 into the OBD socket of the
automobile (10).
Plug the OBD connector of VCI 1000 as straight as possible into the OBD socket to
of the vehicle to avoid contact problems or mechanical wear of VCI and the OBD
socket!
The blue LED (3) is lighted.
If required, e.g. in the event of hard-to-reach OBD sockets, the extension cable (11) can be
used.
Manufacturer-specific adapter cables (12) are available for certain vehicles.
(Please find all currently available cables in chapter Anhang / Appendix at the end of this
manual).
Pushing the button (8) will light a LED (6) installed into the OBD connector (7).
This way, AVL DiTEST VCI 1000 can be adapted easier in dark installation locations.
3. Establish a Bluetooth connection to the PC.
See description of the diagnostic program.
Alternatively, you can also connect AVL DiTEST VCI 1000 to the PC using a USB cable
(9). For this, open the cover (2) on AVL DiTEST VCI 1000 and connect the USB cable (9)
to the USB socket (1).
If a connection to the PC is established, the LED green/red/yellow (4) will light green.
(9)
(2)
Fig. 2-1
2.2

Firmware update

See description of the diagnostic program. Please note that the firmware update cannot be
performed via Bluetooth, but only using a USB cable.
2
NOTICE
PC
Bluetooth stick
(1)
(4) (8)
(7)
(6)
AVL DiTEST VCI 1000
Automobile:
OBD socket
(11)
(12)
manufacturer-specific socket
(10)
Automobile:
User Manual