Kapsys SmartVision 2 Guide De Démarrage Rapide page 9

4.Lastly, replace the back cover by aligning the tabs on the
cover into the slots on the phone. Gently press the cover until
it snaps in place.
Charging the battery
For initial use, it is recommended to charge the battery for
at least four hours. After that you can recharge the battery
as needed.
Connect the USB cable between the SmartVision2 and the
AC charger. Plug the AC charger into any AC outlet and
charge the device. You can also charge your smartphone by
using the USB cable directly on your computer.
It is normal for the Smartphone to heat-up when charging or
during long periods of use.
Turning your smartphone ON/OFF
Turn ON your SmartVision2 with a long press on the power
button placed on the top of the phone. SmartVision2 vibrates
when you successfully turn-it on.
When the phone is turned on for the first time, please follow
the setup instructions (Language selection, profile selection,
etc.)
SmartVision2 is ready to be used when the home screen is
displayed.
When your SmartVision2 is ON, a short key press of the
power button will bring it to standby mode (screen off), or
back to running mode (screen on). The standby mode is
activated after an inactive period for battery safe.
In standby mode, SmartVision2 screen is off but its features
remain enabled. You can still receive incoming calls,
messages, emails, etc.
To turn OFF SmartVision2, long press the power button, then
select "Power OFF" and press the "OK" button. Follow the
instructions.
If the screen remains black or if your phone is no
longer responding, you can force the phone to restart by
simply removing and replacing the battery.