Cleaning The Tool - Makita UH5570 Manuel D'instruction

009289
Installing or removing chip receiver
(accessory)
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing chip
receiver.
NOTE:
When replacing the chip receiver, always wear
•
gloves so that hands and face does not directly
contact the blade. Failure to do so may cause
personal injury.
Always be sure to remove the blade cover before
•
installing the chip receicer.
The chip receiver receives cut-off leaves and
•
alleviates collecting thrown-away leaves. This can
be installed on either side of the tool.
1
3
4
009290
Press the chip receiver on the shear blades so that its
slits overlap with the nuts on the shear blades. At this
time, make sure that the chip receiver does not contact
branch catcher at the top of the shear blades.
1
009291
At this time, the chip receiver needs to be installed so
that its hooks fit into grooves in the shear blade unit.
1. Press
2
2. Chip receiver
3. Nut
4. Shear blade
1. Nut
2. Branch catcher
2
2
3
009292
To remove the chip receiver, press its lever on both sides
so that the hooks are unlocked.
1
2
009293
CAUTION:
The blade cover (standard equipment) cannot be
•
installed on the tool with the chip receiver being
installed. Before carrying or storing, uninstall the
chip receiver and then install the blade cover to
avoid blade exposure.
NOTE:
Check the chip receiver for secure installment
•
before use.
Never try to uninstall the chip receiver by an
•
excessive force with its hooks locked in the blade
unit grooves. Using the excessive force may
damage it.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.

Cleaning the tool

Clean out the tool by wiping off dust with a dry or
soap-dipped rag.
CAUTION:
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
7
1. Hooks
1
2. Fit the hooks
into groove
3. Grooves
1. Press the hooks
on both sides
2. Unlock the
hooks