The Appliance And Environment; Maintenance; Defrosting - Electrolux TG 091 Notice D'utilisation

62 electrolux
Put warm foods into the appliance only
when they are at room temperature.
The condenser must be kept clean.

The appliance and environment

This appliance does not contain gasses
which could damage the ozone layer, in
either its refrigerant circuit or insulation
materials. The appliance shall not be
discarded together with the urban refuse
and rubbish. Avoid damaging the cooling
unit, especially at the rear near the heat
exchanger. Information on your local
disposal sites may be obtained from your
municipal authorities.
The materials used on this appliance
marked with the sympol

Maintenance

Defrosting

Bleeding part of the moisture of cooling
chamber in form of frost and ice goes
with the operation of the appliance.
Thick frost and ice has an insulating effect,
so it reduces cooling efficiency as the
temperature increases, it needs more
energy, at a certain thickness it does not
allow the door of the freezing compartment
to open, possibly the door can be broken.
It is possible to scrape off and remove smaller
frost and ice with the enclosed ice scraper.
The tray in figure is not a piece of
accessories to the appliance!
GB
are recyclable.
When ice coating is so thick that it can
not be removed with the frost scraper
defrosting is necessary. Its frequency
depends on usage.
How to defrost it:
Disconnect the appliance from the
electrical supply. If the plug is not
accessible turn the temperature control
knob to "0" position.
Take the frozen foods out of the appliance
and put them into a basket lined with
paper or cloth. Store them in a possibly
cool place or replace them into a frozen or
fresh food compartment of a refrigerator.
Leave the door open.
Sweep off the melting water occasionally
with a cloth or sponge in direction of sides
which gathers in the outlet channel
practically formed in the bottom of the
appliance and can be removed as follows:
Put a tray high enough in front of the
appliance. Insert the plastic scraper into
the defrost water outlet according to the
picture. Defrost water will flow into the
tray through the outlet.
Defrosting process can be made quicker
by placing a pot or dish filled with warm
water to the cooling plate formed as a shelf.
After defrosting wipe the surfaces and
push defrost water outlet back.
Apply voltage to the appliance.
Turn the temperature control knob to a
medium position and leave to run.
After the red light has gone out put the
foods back.