Craftsman CMXGZBF7124571 Guide D'utilisation page 7

Step 13: (Fig. 13)
1. Tighten all bolts and nuts except for those shown in step
9 that fasten the control bracket to the hitch tube.
Fig. 13
Step 14: (Fig. 14)
1. Slide a spacer (27), a 1/2" washer (35), and the drive
wheel (2) onto the square end of the axle.
2. Slide a 1/2" washer (35) over the axle and secure the
wheel with a 1/8 x 1-1/4" cotter pin (29), spreading the
ends.
Fig. 14
2
27
35
35 29
Step 15: (Fig. 15)
1. Slide a spacer (27), a 1/2" washer (35), and a wheel (2)
onto the round end of the axle.
2. Slide a 1/2" washer (35) over the axle and secure the
wheel with a 1/8 x 1-1/4" cotter pin (29), spreading the
ends.
29
Fig. 15
Step 16: (Fig. 16)
1. Set the adjustable stop at "5" and move the control
handle back against it.
2. Slide the control bracket along the hitch tube until the
flow plate in the bottom of the hopper is open half way.
3. Tighten the bolts and nuts fastening the control bracket.
Do not deform the control bracket.
4. Make sure the flow plate will open and close all the way.
Readjust if necessary.
Fig. 16
ENglISh
35
3
35 27
"5"
5