Philips PerfectCare Pure GC7000 Série Mode D'emploi page 9

Problem
The appliance has
switched off.
The appliance
produces a loud
pumping sound.
Water droplets
come out of the
soleplate.
Dirty water and
impurities come
out of the
soleplate.
Water flushes out
of the soleplate.
The Calc-Clean
process does not
start.
The iron leaves a
shine or an imprint
on the garment.
The ironing board
cover becomes
wet or water
droplets come out
of the soleplate.
Possible cause
The safety auto-off function
was activated. This happens
automatically when the steam
generator has not been used
for more than 5 minutes.
The water tank is empty.
After the Calc-Clean process,
remaining water may drip out
of the soleplate.
The Calc-Clean process has
not been completed.
Impurities or chemicals
present in the water have
deposited in the steam vents
and/or soleplate.
You have accidentally started
the Calc-Clean process
(see chapter 'IMPORTANT -
Cleaning and maintenance').
You have not pressed the
Calc-Clean button for 2
seconds until the appliance
started beeping.
The surface to be ironed was
uneven, for instance because
you were ironing over a seam
or a fold in the garment.
Steam has condensed on the
ironing board cover after a
long ironing session.
You may have an ironing
board that is not designed to
cope with the high steam rate
of the steam generator.
Solution
Set the on/off switch to 'off ' position and
then to 'on' position.
Fill the water tank with water and press the
steam trigger until the pumping sound
becomes softer and steam comes out of
the soleplate.
Wipe the soleplate dry with a piece of
cloth. If the light in the Calc-Clean button
still flashes and the appliance still beeps,
perform the Calc-Clean process
(see chapter 'IMPORTANT - Cleaning and
maintenance').
You have to perform the Calc-Clean
process again (see chapter 'IMPORTANT
- Cleaning and maintenance').
Perform the Calc-Clean process regularly
(see chapter 'IMPORTANT - Cleaning and
maintenance').
Switch off the appliance. Then switch it
back on again. Let the iron heat up until the
'iron ready' light lights up steadily.
See chapter 'IMPORTANT - Cleaning and
maintenance'.
Perfect Care is safe on all garments.
The shine or imprint is not permanent and
will disappear when you wash the garment.
Avoid ironing over seams or folds or you
can place a cotton cloth over the area to
be ironed to avoid imprints.
Replace the ironing board cover if the foam
material has worn out. You can also add an
extra layer of felt material under the ironing
board cover to prevent condensation on
the ironing board.
Put an extra layer of felt material under the
ironing board cover to prevent
condensation on the ironing board.
ENGLISH
9