Philips PerfectCare Pure GC7000 Série Mode D'emploi page 10

ENGLISH
10
Problem
Steam continues to
come out after I
release the steam
trigger.
There is a strong
gush of steam
when I release the
steam trigger after
placing the iron on
the iron platform.
Steam is weak.
Steam does not
come out
immediately when I
press the steam
trigger.
Possible cause
Steam is generated in the
soleplate. When you release
the steam trigger, remaining
water is transformed into
steam. This is normal.
When the iron is tilted
upwards, remaining water is
collected and converted into
strong steam. This is normal.
You do not press the steam
trigger continuously.
You use the ECO mode.
Water is converted into
steam in the soleplate. When
you press the steam trigger, it
will take 1 to 2 seconds until
steam is generated and
released. This is normal.
Solution
Release the steam trigger 2 to 3 seconds
before you place the iron back on the iron
platform or ironing board.
Release the steam trigger 2 to 3 seconds
before you place the iron back on the iron
platform or ironing board.
Keep the steam trigger pressed
continuously when you move the iron over
the fabric.
For more steam, switch off the ECO mode
by pressing the ECO button. The green
ECO light goes off.
Keep the steam trigger pressed
continuously when you move the iron over
the fabric.