Sony Cyber-shot CSS-TNA Mode D'emploi page 16

Symptom
Your computer does not recognize the
camera
Buttons on the Cyber-shot Station or
the remote control do not work, and no
operations can be performed
The connection between the printer
and the Cyber-shot Station cannot be
established
Unable to print still images
Unable to attach the camera on the
Cyber-shot Station
16-GB
Cause/Solution
• The camera is turned off.
t Turn on the camera.
• You are not using the supplied USB cable.
t Use the supplied USB cable.
• The USB cable is not connected firmly.
t Disconnect both ends of the USB cable and
connect them again firmly. Make sure that the
camera is set to "USB Mode".
• The camera is not placed on the Cyber-shot Station
correctly.
t Place the camera correctly.
• The USB jacks on your computer are connected to
other devices besides the keyboard, the mouse,
and the Cyber-shot Station.
t Disconnect all devices except the keyboard, the
mouse, and the Cyber-shot Station from the
USB jacks.
• The AC Adaptor is disconnected.
t Connect the AC Adaptor properly.
• The battery in the remote control is dead.
t Replace the battery with a new one.
• The printer may not be PictBridge-compliant.
t Ask the printer manufacturer whether your
printer is PictBridge-compliant or not.
• The printer is not set for the connection with the
camera.
t Make sure that the printer is turned on to
connect with the camera.
• The USB mode setting in "SET UP" is not
appropriate.
t Set the [USB connection] on the camera.
t For further details, refer to the operating
instructions supplied with the camera.
• The Cyber-shot Station is not connected to the
printer properly.
t Make sure that the Cyber-shot Station and the
printer is connected with the USB cable
properly.
• The camera is not placed on the Cyber-shot Station
correctly.
t Place the camera correctly.
• The printer is not turned on.
t Turn on the printer.
For further infomation, refer to the operating
instructions supplied with the printer.
*
Still images taken with other cameras and images
modified with a computer may not be printed.
• The designated Adaptor plate is not attached to
the Cyber-shot Station.
t Attach the designated Adaptor plate to the
Cyber-shot Station.