Starting An Engine Without A Battery; Using The Usb Ports - Absaar AB-MJS270 Manuel De L'utilisateur

8.2 Starting an engine without a battery.

Important: Starting up the engine without the vehicle's original battery using only the Mini
Jumpstarter can cause damage to the electrical circuits of the vehicle.
-Connect the clamp connector (11) to the output (10) of the Mini Jumpstarter and then
connect the clamps to the correct terminals of the vehicle's battery:
For a vehicle with a negative earth system; Connect the red positive clamp (+) of the
Mini Jumpstarter to the red positive terminal (POS, P, +) of the battery. Then connect the black
negative clamp (-) of the Mini Jumpstarter to the chassis of the vehicle or to the engine block.
For a vehicle with a positive earth system; Connect the black negative clamp(-) to the
black negative terminal (NEG, N, -) of the battery. Then connect thered positive clamp
(+) to the chassis of the vehicle or the engine block.
- Press the "Override" button for 2 seconds in order to switch to "Override" mode. The words
"Override" and "Ready" will be displayed on LCD screen with a timer indicating the time
remaining before the end of the start-up procedure (press the "Override" button again to
return to the main menu and stop the "Override" mode).
Note: When the "Override" mode is activated, the short-circuit protection is deactivated.
In "Override" mode, alwaysensure that the clamps are properly connected
to the correct terminals so that they cannot come into direct contact with
one another (short-circuit).
- Carry out a start-up attempt within 20 seconds of activating the "Override"mode, between
each start-up attempt. The word "Cooling" will be displayed on the LCD screen along with a
timer indicating thetime needed for the Mini Jumpstarter to cool down. At the end of this
timer function, press the "Override" button again for 2 seconds in order to trigger the start-
up procedure again.
- After starting up the engine, disconnect the black clamp (-) followed by the red one (+).

8.3 Using the USB ports.

The USB ports provide 2.4 Amperes of current and a voltage of 5Volts.
- Press the power supply button (2) for 2 seconds in order to switch on theMini
Jumpstarter and activate the USB ports.
- Connect the device that requires power to one of the USB ports.
9
EN