Smart Grid Function - Samsung RS22HDHPNSR Mode D'emploi

MAC Address Display Mode
This function displays the MAC address of the
Wi-Fi module on the refrigerator display.
The refrigerator displays the MAC address of the
Wi-Fi module for 1 minute.
1. Press and hold the Power Freeze and Energy
Saver buttons at the same time for 3 seconds.
2. A Buzzer sounds. Four of the twelve Mac
address of the Wi-Fi module are displayed
in turns in the freezer and fridge temperature
displays for 1 minute. For example, if the Wi-Fi
module's MAC address is "11-22-33-44-55-
66", the MAC address is displayed as follows:
"11 22" → "33 44" → "55 66" → ---- → "11 22"
for 1 minute.
3. After 1 minute, the display returns to the normal
state and the Buzzer sounds again.
If the Mac addresses are not available or
there is no Wi-Fi module, `----' is displayed
on the freezer and fridge temperature
displays.
DA68-02966A-01.indb 24

SMART GRID Function

(Demand Response)
When the refrigerator operates in SMART
GRID (Demand Response) mode, the E-Smart
Refrigerator function can control energy usage
or delay the operation of some functions to save
money when energy prices or demand are the
highest.
You can deactivate the SMART GRID
(Demand Response) function at any
time.
(Using the Override On/Off function)
To use the SMART GRID (Demand
Response) function, you need a
separate contract with your utility
company.
Using the SMART GRID (Demand
Response) Function
This feature monitors energy prices and demand
information from your utility company and sends
notifications to the refrigerator to run high energy-
consuming tasks during off-peak times when
electricity costs and demand are lower.
If the refrigerator receives a control signal from
the Utility Company, the refrigerator will display
the DAL (L3) ~ TALR (L4) levels on the refrigerator
display and control the power consumption
according to the level.
[Exception condition] The DAL and TALR control
signals from an utility company work as long as
product performance is maintained.
If the refrigerator receives the SMART GRID
(Demand Response) signal (DAL or TALR), the
refrigerator will operate in Delay Appliance Load
(Display: L3) or Temporary Appliance Load
Reduction (Display: L4) mode.
English - 24
2014. 2. 26. 6:41