TFK JOGGSTER adventure Notice D'utilisation page 9

OPERATING AND ASSEMBLING MANUAL
(Fig. I) In order to be able to use the Joggster Adventure, always first
fold the lower section of the frame open. Press the basket frame (1)
downwards with the hand or the foot, until it audibly locks into place.
This is extremely important for stability.
(Fig. II) Then swivel the push bar (2) upwards until the red double lock
(3) locks into place. Then close the locks (4) on the left and right over
the folding joint.
• (Fig. III) Before assembling the seat, you have to remove the basic
adapters. The seat is mounted to the frame with 3 push buttons (a)
on each side of the frame. Additionally, it's fixed to the foot rest with
2 pushbuttons (b). On each side of the seat, there're 2 push buttons
(c) where the wind protection of the hood are fixed.
• (Fig. IV) Insert the hood (5) on the left and right into the holders (6) on
the push bar (2). It is then secured with on the backrest with four push
buttons (d).
(Fig. V) At the initial assembly of the rear wheels, first position the
brake calliper (7) on the brake disc (8). First push the axle (9) through
the wheel hub and then into the provided bore on the rear axle until
it locks into place. Then engage the brake cable (10) into the mount
on the central brake cylinder (11) and check the function of the
brake by actuating the handbrake lever (24) on the push bar (2). If
you would like to remove the wheels, release the brake cable (10)
and press the TFK button (9) in the centre of the wheel. You can now
remove the wheels.
(Fig. VI) Insert the front wheel (12) into the provided opening until it
audibly locks into place. At position 1, the front wheel (12) can turn
freely and at position 2 it is jammed. If you press the red button with
the arrow (13), you can remove the wheel downwards. Inside of the
wheel attachment you find two set screws (14) to adjust the straight
running when necessary.
(Fig. VII) The backrest can be adjusted by pulling the strap (16) on
the backrest.