Philips GC6400 Série Mode D'emploi page 13

Problem Cause
You have been ironing at too high
temperatures.
Steam escapes You may not have tightened the steam
from the illing tank cap properly or you have spilled
hole area during some water around the illing hole
ironing.
Wet spots The wet spots that appear on your
appear on the garment after you have steam ironed
garment during for some time may be caused by
ironing steam that has condensed onto the
ironing board. Iron the wet spots
without steam for some time to dry
them. If the underside of the ironing
board is wet, wipe it dry with a piece
of dry cloth.
I cannot put the This iron has been designed in such a
iron on its heel. way that it can only be placed
horizontally.
EnGlISh
Solution
Clean the soleplate with a damp
cloth. Set the iron to the required
ironing temperature (see chapter
'Preparing for use', section 'Setting
the temperature').
Switch off the appliance and let it
cool down. Remove the steam tank
cap, wipe away the water round the
illing hole and tighten the steam
tank cap again. Then switch on the
appliance again.
To prevent steam from condensing
onto the ironing board, use an
ironing board with a wire mesh top.
Place the iron on the heat-resistant
iron resting mat.
13