Makita DHG180 Manuel D'instruction page 6

ASSEMBLY
Attaching and detaching
accessories
The heat gun can use with accessory or without the
accessories according to various of heating purpose.
Attaching the accessory
— Choose the appropriate nozzle according to the
heating applications.
— Push the fitting end of the nozzle onto the heating
nozzle.
MOUNTING THE CORRECT
ACCESSORY (IF APPLICABLE)
Shape and
description
Glass protection Drying the putty on the window flame
nozzle
Removing putty from the window frame
Protect windows
with the scraper (optional accessory)
when stripping
frames
Wide-slot nozzle Heat packaging for heat shrink films
For heating spread
over wider area
Reflector nozzle Heat shrinking for heat shrink tubes
Bending of resin tube
Reduction nozzle Paint stripping with the scraper (optional
For heating concen- accessory)
trated over small
area
Example
6 ENGLISH
Overlap welding Patching a vinyl sheet with the pressure
nozzle
roller (optional accessory)
(Optional
accessory)
Solder sleeves Heat shrinking for heat shrink tubes
reflector
(Optional
accessory)
Welding nozzle For heating concentrated over small
(Optional area
accessory)
WARNING:
Ensure the power tool is switched
off and battery cartridge is removed from the
power tool before attaching the accessories.
Attaching the accessories with switch on or battery
cartridge attached may cause the risk of accidents.
WARNING:
Make sure to attach the accesso-
ries securely. Otherwise the accessory may fall off
accidently and cause burn injury.
Detaching the accessory
Turn the front cover in the direction of the arrow in the
illustration, the accessory will be ejected. This allows
you to remove nozzles without touching them while they
are still hot.
Fig.2