Epson BrightLink Pro 1430Wi Guide D'installation page 22

14. Perform touch calibration by pressing Menu on the remote control. On the Extended menu, select
Easy Interactive Function, then Touch Unit Setup. Select Touch Calibration and follow the
instructions.
H
Store the markers and attach labels
1. Store the markers inside the Touch Unit.
2. Attach the labels to the tabs on either side of the Touch Unit. Match the centers of the labels with the
tabs on the Touch Unit.
If the Touch Unit moves out of position, use the position of the labels to determine
where to reposition the Touch Unit.
I
Attach cover
Attach the dial cover. Make sure to tighten the screw at the bottom of the cover.
22