Operating Modes; Comfort Mode; Night Reduction Mode (Eco); Freeze Protection Mode - Fondital MANIVA 3110 Manuel D'installation

4.1 Operating modes

4.1.1 COMFORT MODE:

It is the standard mode of use of the radiator to keep the ambient temperature to the value set.
To adjust the temperature you wish to set
1. Keep the "MODE" key pressed until symbol is displayed
2. adjust the temperature using "+" and "-" keys
3. Press "OK" to confirm
The comfort set-point can be adjusted by the user, in steps of 0.5°C within the range between
7°C and 30°C. The maximum value depends on the adjustment made in configuration mode, as explained in paragraph 4.5.1 (default value:
28°C).

4.1.2 NIGHT REDUCTION MODE (ECO)

In this mode the set temperature is 3.5 °C lower than the one set in comfort
mode.
It is possible to change the set temperature using buttons + and -, at steps of
0.5 °C and confirm with OK, with the following limits: it must never exceed the
comfort set point and 19 °C.
It is also possible to change the night reduction value by 3.5 °C to a different
value, from 0 to 10 °C (see paragraph 4.5.2). In this case the ECO temperature
value can not be changed with buttons + and - and will have the same value
set for the comfort mode reduced by the night reduction value.
4.1.3 FROST PROTECTION MODE
By selecting this mode, the set ambient temperature is 7°C, and cannot be edited by the user.

4.1.4 STAND-BY MODE:

Key allows switching on or off the radiator, regardless of the operating mode.
The switching off has the priority over all the menus, including those relating to adjustment and configuration.
Should the device be switched off while a value is being edited and, should such a value not have been saved before the switching off, the
edited value will not be stored inside memory.
An audible signal (3 BEEPS) will be emitted upon device switching off.
Another audible signal (1 BEEP) will be emitted upon device switching on.
Warning: in this position the radiator is anyway powered.

4.1.5 PILOT WIRE MODE (FOR FRANCE ONLY).

In this mode the radiator is controlled by a remote control unit.
The temperature set depends on the Pilot Wire controls. This mode can be used only in France.
This mode can be selected using the "MODE" key.
During operation in "auto" mode, the set temperature value can be edited using "+" and "-" keys, thus independently from them set-point.
This derogated set-point stays valid until the next order change by the Pilot wire.
The displaying of a "Hand" shaped pictogram means that one derogation is in progress.
.
MODE
PROG
EN-26
AUTO
+
-
OK
MODE
PROG
MODE
PROG
MODE
PROG
+
-
OK
+
-
OK
+
-
OK