Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
10. Add inside door panel back into the dryer door by sliding the
top into the top trim piece and then lower door down. Then
press down on the corners to snap into place with the hinges
lined up with the hinge holes.
11. Install 6 hinge screws and the other 4 screws.
12. Install hinge covers and plugs. Hinge covers will go in
sideways to then rotate 90° and snap into place.
13. Hang door by placing set pin in dryer cabinet hole and slide
door down. Using a T25
then (B) screws. Tighten all hinge screws.
screwdriver, install (A) screws and
®
A
B
A
B
25
Publicité
Table des Matières
