Module Intercalaire; Removing The Interposer Module; Installing The Interposer Module - Dell Precision 3240 Compact Manuel De Maintenance

Module intercalaire

Removing the interposer module

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the top cover (side bezel)
4. Remove the front bezel.
5. Remove the fan assembly.
NOTE: This step is valid for system configuration that is shipped with 80 W CPU.
6. Remove the riser card.
About this task
The following images indicate the location of the interposer module and provide a visual representation of the removal procedure.
Steps
1. Flip open the actuator and disconnect the SATA FPC cable from the system board.
2. Loosen and remove the single screw (M3x5) securing the interposer module to the system board.

Installing the interposer module

Prerequisites
Si vous remplacez un composant, retirez le composant existant avant d'exécuter la procédure d'installation.
About this task
The following image indicates the location of the interposer module and provides a visual representation of the installation procedure.
60 Démontage et remontage
before working inside your computer.