Heating Cycle Setting/Assembly; Setting The Correct Time - Grasslin Famoso 555 Mode D'emploi

3.3 Heating cycle setting/assembly

The heating-cycle setting (CDF value) is
for adapting to the control range.
This is affected by:
– Room size
– Type of heating, e. g. convectors,
storey heating
– Type of assembly
– Temperature control/thermostat
The set value can be altered to achieve
an optimum heating control.
Set the value accordingly with the po-
tentiometer on the rear of the unit.
(Factory setting 4)
Recommended positions for
Underfloor heating
• Electric
• Warm water
Mount device on base and lock.
GB
Position
4-5
5-6
4. Setting the correct time/weekday
Slide the cover upwards and remove.
4. Setting the correct time/weekday
Only turn in the direction of the arrow
Day time switch
e. g. 14.00 h
Turn the dial in the direction of the
arrow until the desired hour is aligned
with the locating arrow.
The precise setting is made with the
minute hand.
Week time switch
e. g. Tuesday 14.00 h
Turn the dial in the direction of the
arrow until the desired week day is in
the area of the locating arrow.
The precise setting is made with the
minute hand.
6
GB