Thetford SANICON TURBO 500 S Manuel De L'utilisateur page 6

Installation, cont'd.
Connect Electrical
Refer to Fig. 1.
5A.1
5A.2
5A
Wires should be covered to protect from foreign
AVISO
! ! ! ! NOTICE ATTENTION CAUTION ATENCIÓN AVIS DANGER
objects and water
ATTENTION ATTENTION ATTENTION
Ref. Description
5A RV Power Source (Battery shown)
5A.1 Positive Battery Terminal
5A.2 Ground Lug / Chassis Ground or negative battery
terminal
2B Relay
K1 Pump Assembly
K1.4 Pump Black Wire
K1.5 Pump Blue Wire
K1.6 Pump Black Wire - Negative (Long Wire)
K3 Switch Box / Wiring
K3.1 Switch Box Red Wire
K4 Fuse Holder / 35AMP Fuse
Wire Size
■ Wire size is dependent on the distance between the pump
and power source. Actual wire sizes should be calculated
according to installation. Refer to Fig. 3.
■ Excess wire can be cut to length.
97572 Rev. B (07/10/2017)
K4
K1.6
Black wire connects to
negative terminal of battery
or vehicle "ground"
Fig. 5
RED power wire & fuse from
battery to switch box
2B
K1
Attach the Wires
Refer to Fig. 1 and Fig. 4.
1. Locate the power source (battery or other main power source)
where the electrical connection will be made.
2. Disconnect positive wire(s) to the RV battery
3. Attach the switch box
4. Route and connect the black and blue switch box leads to
the short black
(K1.4)
supplied electrical connectors. To seal heat shrink connectors,
heat the connectors after wires are connected. Connect
additional wiring if required.
5. Route the long black wire (negative)
assembly (K1) to the battery's
to a ground lug on the RV, or to an OEM provided chassis
ground (5A.2) .
6. Route the red wire
(K3.1)
fuse holder (K4) .
7. Crimp one end of the fuse holder to the red wire
attach the other end to the positive battery terminal
The fuse holder
NOTICE
the power source.
8. Protect all the wiring for the SANICON® system with a wire
sheath (not provided).
9. Reconnect the positive wire(s) that was removed in Step 2 of
this procedure to the RV's battery.
6
K3
K1.5
K1.4
Blue and black wires connect Blue and black wires connect
from pump to blue and black from pump to blue and black
switch box wires switch box wires
(5A)
(K3) inside RV compartment
and blue pump leads using
(K1.5)
(K1.6) from the pump
(5A) negative terminal, or
from the switch box
(K3)
should be mounted within 18" of
(K4)
®
SANICON Turbo - Model 500
.
(4D) .
to the
and
(K3.1)
.
(5A.1)