Automatic Switch-Off - SEVERIN KA 4460 Mode D'emploi

∙ When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
∙ Do not allow the power cord to hang free;
the cord must be kept well away from hot
parts of the appliance.
∙ No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
Setting the time
∙ Insert the plug into a suitable wall outlet.
The coffee maker is still switched off, with
the LCD display fl ashing 0000.
∙ To set the time, fi rst press the PROG key.
∙ The internal clock uses a 24-hour display
format. The current time is set by using
the h button for the hours, while the min
button is used to set the minutes.
Example:
∙ The current time is 15.30 (3.30 pm).
∙ Press the PROG key. The display starts
fl ashing 00:00, and the h and min buttons
light up blue.
∙ With these buttons showing blue, press the
h button repeatedly (or keep it pressed
for the necessary length of time) until the
display shows 15:00.
∙ Then press the min button repeatedly (or
keep it pressed) until the display shows
15:30.
∙ After 5 seconds or so, the display stops
fl ashing and the appliance is ready for use.
Timer
∙ To start the brewing process with a
delayed timer setting, the current time
must fi rst be set as described above.
∙ Then set the timer to the desired time as
follows:
12
∙ Press the PROG button twice. The LCD
display shows AUTO and the time last
entered, or 00:00.
∙ Use the buttons h und min to set the
desired time.
∙ The pre-set time will now be stored in the
appliance within 5 seconds.
∙ The AUTO button lights up, and the
current and pre-programmed starting time
appear alternately in the display.
∙ At the pre-programmed time, the coffee
maker will automatically switch on.
On/Off button
∙ The On/Off button is used for immediate
starting or stopping of the brewing cycle.
∙ In this case, it is not necessary to set the
current time fi rst, and if the appliance is
started manually without the current time
set, the LCD display will simply show the
time remaining until the automatic switch-
off.
∙ To interrupt the brewing cycle, press the
On/Off button again.
Aroma function
∙ To obtain a stronger coffee fl avour, the
appliance is equipped with a special
aroma function. With this setting, the
hot water is released at intervals. This is
especially useful when preparing smaller
quantities of coffee.
∙ To select this function, press the
button. The indicator light comes on.

Automatic switch-off

To save energy, the heating element will
automatically switch off about 40 minutes
after the brewing cycle has been started.