REVER 9340 N Notice D'utilisation Et Entretien page 103

Line: DE LUXE INOX
Steel casing.
Professional pump.
Professional vacuum gauge.
Automatic operation.
Adjustable welding time.
Air intake for container coupling.
Power 200W – 210W
Max. vacuum level -850 mbar / -920 mbar
Aspiration capacity 18 lt/min – 32 lt/min
COMPONENTS
1. Pump switch (ON/OFF)
2. Welding switch
3. Vacuum gauge
4. Cover 10. Bar-pressing profile
5. Vacuum chamber gasket
6. Vacuum chamber
Cod. 9706 N – 9706 NP – 9707 N
USE OF THE MACHINE
Cod. 9706 N VACUUM UNIT DE LUXE INOX
Cod. 9706 NP VACUUM UNIT DE LUXE INOX DOUBLE PISTON POMP
The machine permits the vacuum packaging conservation of food products, so as to
extend their conservation in time
Standard factory regulations provide a welding time of about 5 time/power units (suitable
for standard vacuum bags with 95/105 micron thickness), and automatic use.
SETTING THE MACHINE TO MANUAL/AUTOMATIC USE
To set the machine to manual use, proceed as described below:
Before connecting the plug to power supply, press and hold on pump switch (1);
Connect the plug to power supply;
Wait for at least 5 seconds;
Release the switch.
To set the machine to automatic use, proceed as described below:
Before connecting the plug to power supply, press and hold on welding switch (2);
Connect the plug to power supply;
Wait for at least 5 seconds;
Release the switch.
(This setting will last when unplugging the machine, until a new programming operation will
be made).
SEAL POWER SETTING
1- With the appliance connected to the power supply
2- Push 10 times in 10 seconds the seal switch (2),
3- Push the pump switch (1) once per each unit of time/power you need ( default set is 5 units),
4- If pushing on pump switch (1), the pump start, it means the cycle was not correct, re-start
from point 1
7. Sealing bar
8. Air suction plug
9. Slide
11. Green LED ( 9707 N)
12. Red LED ( 9707 N)
103