Télécharger Imprimer la page

Removing The Seat Cover - GB Platinum ELIAN-FIX Mode D'emploi

Publicité

REMOVING THE SEAT COVER

The seat cover consists of five parts which are fixed to the seat
with velcro, press studs or button holes. Once you have released
the fasteners, the cover parts can be removed. To remove the
covers, please follow the instructions below:
NOTE! Before removing the separate parts of the seat cover,
please ensure that the cover is already positioned above the
decorative silver parts.
• Undo the press studs on the lower side of the cover for the
adjustable headrest. Then you can remove the cover upwards.
• Activate the adjustment handle for the headrest and move this
to its highest position.
• Loosen the covers on the rear side of the headrest. Then pull the
cover off forwards.
• Pull down the cover on the left and right side panel of the
shoulder rest. Then undo the press studs on the interior of the
shoulder wings in order to be able to entirely remove the cover.
• Loosen the backrest cover from the seat. Then pull the cover
off forwards.
• Then thread the elastic bands out on the under side of the seat
area, and withdraw the seat cushion cover forwards.
To put the covers back on the seat, proceed as above in reverse
order. Make sure that the red belt guide 20 always rests visible
above the seat cover.
TOGLIERE IL RIVESTIMENTO
Il rivestimento è costituito da 5 parti unite al seggiolino mediante
velcro, bottoni a pressione o asole. Una volta slacciati tuti i punti
di fissaggio, è possibile rimuovere le parti del rivestimento. Per
togliere le parti del rivestimento seguire i passaggi sotto descritti:
NOTA BENE! Priam di togliere le singole parti del rivestimento è
bene estrarre il tessuto dalle parti decorative in argento.
• Slacciare i bottoni a pressione sul lato inferiore del rivestimento
del poggiatesta regolabile. Quindi sfilare il rivestimento tirandolo
verso l'alto.
• Attivare la maniglia del poggiatesta e sollevarlo al massimo.
• Allentare il rivestimento nella parte posteriore del poggiatesta.
Quindi sfilare i tessuto tirando in avanti.
• Tirare verso il basso il rivestimento sui due lati, sx e dx, del
pannello di protezione spalle. Slacciare i pulsanti a pressione
nella parte interna delle ali per le spalle per riuscire a rimuovere
completamente il tessuto.
• Allentare il rivestimento dello schienale dal seggiolino. Quindi
sfilare il tessuto tirandolo in avanti.
• Quindi sfilare gli elastici nel lato inferiore dell'area seduta e tirare
il rivestimento della seduta in avanti.
Per rimettere il rivestimento, seguire i passaggi sopra descritti
nell'ordine inverso. Prestare attenzione affinché le guide cintura di
colore rosso 20 siano sempre ben visibili al di sopra del tessuto di
rivestimento.
27

Publicité

loading