Bosch HMB5020 Manuel D'utilisation page 17

Timer Feature
To Use as a Kitchen Timer
Example:
To count down 5 minutes
To set Stand Time
Example:
To cook at P6 power for
3 minutes, with stand time of
5 minutes
To set Delay Start
Example:
To delay the start of cooking for
5 minutes, and cook at P6 power
for 3 minutes.
Notes
This feature allows you to program the oven as a kitchen timer. It can also be used
to program a standing time after cooking is completed and/or to program a delay
start.
CAUTION: If oven lamp is lit while using the timer feature, the oven is incorrectly
programed. Stop oven immediately and re read instructions.
1. Press Timer.
2. Set desired amount of time using number pads.
(up to 99 minutes and 99 seconds).
3. Press Start.
Time will count down without oven operating.
1. Press Power Level pad 5 times.
2. Set desired cooking time using number pads.
3. Press Timer.
4. Set desired amount of Stand Time using number pads.
(up to 99 minutes and 99 seconds).
5. Press Start.
Cooking will start. After cooking, stand time will count down without oven
operating.
1. Press Timer.
2. Enter desired amount of delay time using number pads.
(up to 99 minutes and 99 seconds).
3. Press Power level 5 times.
4. Set desired cooking time using number pads.
5. Press Start.
Delay time will count down. Then cooking will start.
When each stage finishes, a two beep signal sounds. At the end of the program,
D
the oven will beep five times.
If the oven door is opened during Stand Time, Kitchen Timer or Delay Time, the
D
time on the display will continue to count down.
Stand time and Delay start cannot be programmed before any automatic
D
Function. This is to prevent the starting temperature of food from rising before
defrosting or cooking begins. A change in starting temperature could cause
inaccurate results.
17