Device-Specific Safety Information - MeisterCraft MFF 860 Traduction Du Manuel D'utilisation Original

5458560-Flachduebe-man 17.02.14 11:38 Seite 32
that cannot be controlled with the
switch is dangerous and must be
repaired.
• Disconnect the plug from the power
source and/or remove the
rechargeable battery before making
any adjustments, changing
accessories, or storing the device.
Such preventive safety measures
reduce the risk of starting the power
tool accidentally.
• Keep power tools that are not in use
stored out of the reach of children.
Do not allow persons to operate the
unit who are not familiar with it, or
who have not read these
instructions. Power tools are
dangerous in the hands of untrained
users.
• Take good care of your device.
Check to ensure that all of the
moving parts function without faults
and do not stick; check whether
parts are broken or so damaged that
they may affect the functioning of
the electrical tool. Have any
damaged parts repaired before using
the device. Many accidents are
caused by poorly maintained power
tools.
• Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
jam and are easier to control.
• Use the power tool, accessories and
other tools etc. in accordance with
these instructions. Take account of
the working conditions and the task
to be carried out. Use of the power
tool for purposes for which it was not
intended may result in a hazardous
situation.
32
Servicing
• Have your power tool serviced by a
qualified repair person using only
original replacement parts. This
ensures that the safety of your power
tool remains unaffected.
6 – Device-specific safety
information
• Milling discs made of high-speed steel
may not be used.
• Milling discs that do not correspond to
the characteristic data specified in this
operating manual may not be used.
• Attention should be paid to ensure that
the milling disc is suitable for the
spindle revolutions of the tool.
• Ensure that all of the moving parts of
the milling plate are able to move
without catching. Never block it.
• Only use sharp milling discs.
• Fix wooden items in place firmly before
processing. Never hold them by hand.
• Do not use flanges/flange nuts with
drilled holes that are larger or smaller
than those of the milling disc.
• The milling disc may not be braked by
hand or using mechanical aids.
• The machine is not be used for
stationary operation.
• Deformed or cracked milling discs may
not be used.
• Before changing discs or performing
any care or maintenance work,
disconnect from the power.