Saitek Cyborg 3D Rumble Force Stick Manuel D'utilisation page 6

Full Install (Drivers and Programming Software)
This installation will install the drivers and the Saitek Smart Technology programming software for the Saitek controller.
Follow points 1 – 7 of the install procedure in Quick Install (Drivers Only), then at the Programming Software screen, select Advanced User and
1
click Next.
At the Programmable Controller Drivers screen, click Update and follow the on-screen instructions.
2
Then at the Installation of programming software successful screen, click Next.
3
At the Registration screen, select Register and follow the on-screen instructions or select Register Later and click Next.
4
Upon completion of the installation, you have the option to Run Profile Editor, which will give you a view of the 3-D programming environment. If
5
you do not wish to see the Profile Editor at this point, just click on Finish to complete the installation. Your Saitek controller is now ready for use
with your favorite games.
For a complete guide on how to program your Saitek controller, visit the Saitek website at www.saitek.com.
Installation for Users of Windows® 98 and Me
Quick Install (Drivers Only)
This installation will install the drivers for the Saitek controller only.
Note: Please do not connect your controller until asked to by the installation procedure.
1 With your computer switched on, close down any programs that are currently running and insert the Saitek Smart Technology CD into your
CD-ROM drive.
When the Welcome screen appears, click Next to continue. (If the CD does not run automatically, select Start from the Windows® Taskbar, then
2
Run and type D:\Setup.exe and click OK).
After reading and accepting the Disclaimer, click Next to continue.
3
Note: For your controller to work, you must have a minimum of Microsoft® DirectX® 7.0a installed on your computer. The installer will automatically
recognize if this software needs to be added, and will allow you to install it directly from the Saitek Product Companion CD, if necessary.
If you are asked to install Microsoft® DirectX® 7.0a, click Install and follow the on-screen instructions, and then restart your computer when prompt-
ed. Make sure that you leave the Saitek CD in the drive when restarting. After this software has been installed, you will automatically be taken to
the installation to continue with the next step.