Saitek Cyborg 3D Rumble Force Stick Manuel D'utilisation page 5

At the Installation of programming software successful screen, click Next.
3
At the Registration screen, select Register and follow the on-screen instructions or select Register Later and click Next.
4
Upon completion of the installation, you have the option to Run Profile Editor, which will give you a view of the 3-D programming environment. If
5
you do not wish to see the Profile Editor at this point, just click on Finish to complete the installation. Your Saitek controller is now ready for use
with your favorite games.
For a complete guide on how to program your Saitek controller, visit the Saitek website at www.saitek.com.
Installation for Users of Windows® 2000
Quick Install (Drivers Only)
This installation will ONLY install the drivers for your Saitek controller. The Full Install (below), will install the drivers and the Saitek Smart Technology
programming software for your Saitek controller.
Note: Please do not connect your Saitek controller until asked to by the installation procedure.
1 With your computer switched on, close down any programs that are currently running and insert the Saitek Smart Technology CD into your
CD-ROM drive.
When the Welcome screen appears, click Next to continue. (If the CD does not run automatically, select Start from the Windows® Taskbar, then
2
Run and type D:\Install.exe and click OK - where D:\ is letter of your CD-ROM drive).
After reading the Disclaimer, select the I accept the terms of the Disclaimer option and click Next to continue.
3
At the Device Driver Installation screen, click on Next and follow the on-screen instructions.
4
When prompted, plug your controller's USB connector into your computer, then click on Configure.
5
When the Controller Properties screen appears, click Next to view the Test screen.
6
Now try out all your controller's buttons and controls to show that it is working properly. When you have finished, click OK.
7
At the Programming Software screen, select Typical User and click Next.
8
At the Registration screen, select Register and follow the on-screen instructions or select Register Later and click Next.
9
10 Click on Finish to complete the installation. Your Saitek controller is now ready for use with your favorite games.