Saitek Cyborg 3D Rumble Force Stick Manuel D'utilisation page 4

Installation for Users of Windows® XP
Quick Install (Drivers Only)
This installation will ONLY install the drivers for your Saitek controller. The Full Install (below), will install the drivers and the Saitek Smart Technology
programming software for your Saitek controller.
Note: Please do not connect your Saitek controller until asked to by the installation procedure.
1 With your computer switched on, close down any programs that are currently running and insert the Saitek Smart Technology CD into your
CD-ROM drive.
When the Welcome screen appears, click Next to continue. (If the CD does not run automatically, select Start from the Windows® Taskbar, then
2
Run and type D:\Install.exe and click OK - where D:\ is letter of your CD-ROM drive).
After reading the Disclaimer, select the I accept the terms of the Disclaimer option and click Next to continue.
3
At the Device Driver Installation screen, click on Next and follow the on-screen instructions.
4
When prompted, plug your controller's USB connector into your computer, then click on Configure and then Continue Anyway. Follow the
5
on-screen instructions until you reach the Controller Properties screen.
When the Controller Properties screen appears, click Next to view the Test screen.
6
Now try out all your controller's buttons and controls to show that it is working properly. When you have finished, click OK.
7
At the Programming Software screen, select Typical User and click Next.
8
At the Registration screen, select Register my Saitek controller online and follow the on-screen instructions or select Register Later and click Next.
9
10 Click on Finish to complete the installation. Your Saitek controller is now ready for use with your favorite games.
Full Install (Drivers and Programming Software)
This installation will install the drivers and the Saitek Smart Technology programming software for the Saitek controller.
Follow points 1 – 7 of the install procedure in Quick Install (Drivers Only), then at the Programming Software screen, select Advanced User and
1
click Next.
At the Programmable Controller Drivers screen, click Update and follow the on-screen instructions. At this point you will be asked to install such
2
features as the Saitek Magic Mouse and Saitek Magic Keyboard (these are what XP calls the various elements of your Saitek controller). Continue
to click on Next, Continue Anyway and Finish to accept the installation until the Installation of programming software successful screen appears.