Assembly; Operation; Applications; Installing/Removing Battery Pack - Ryobi P770 Manuel D'utilisation

UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled to the
product by the manufacturer and require customer instal-
lation. Use of a product that may have been improperly
assembled could result in serious personal injury.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse and
could result in a hazardous condition leading to possible
serious personal injury.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.

ASSEMBLY

WET/DRY VAC ASSEMBLY
See Figure 1, page 8.
 Unlock the four locking latches and remove the lid.
 Remove the hose and attachments from the collection
container.
NOTE: Make sure the filter is seated properly for dry
vacuuming. Remove the filter for wet vacuuming.
 Replace the lid and lock securely.
 Press the locking tab on the flexible hose and insert into
the vacuum port. Release the tab and make sure the hose
is secure.
 Attach the tapered end of the flexible hose into the ex-
tension wand. Connect second extension wand and/or
accessories as needed.
 To remove, pull the extension wands and accessories
from the flexible hose.
 To remove the flexible hose, press the locking tab as
shown and pull away from the vacuum port.
NOTE: The flexible hose and accessories can be stored
in the collection container or on the lid of the wet/dry vac.

OPERATION

WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.

APPLICATIONS

You may use this product for the following purpose:
 Light-duty vacuuming of wet or dry surfaces

INSTALLING/REMOVING BATTERY PACK

See Figure 2, page 8.
 Set the ON/OFF switch to the OFF position.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and that battery pack is secured in the
product before beginning operation.
 Depress the latches to remove the battery pack.
5 — English