Pioneer PDP-S51 Mode D'emploi page 3

MOUNTING THE SPEAKERS
TO YOUR PLASMA DISPLAY
NOTE:
The diagram depicts the mounting of the right
speaker. The left speaker mounts in the same way.
1. 1 Attach the speakers to the speakers mounting
bracket (top and bottom) with the speakers
mounting screws (M4 × 10 mm).
2 Remove the seals from the cushions and then
attach the cushions to the sides of the speakers
in the locations indicated in the diagram below.
Speaker Mounting
Bracket (For
RIGHT-TOP)
Speakers Mounting
Screw (M4 × 10 mm)
Speaker Mounting
Bracket (For RIGHT-
BOTTOM)
Cushion
Cushion
2. Loosely attach the speakers mounting screws
(M5 × 10 mm) to the plasma display (one location
on the left and one on the right).
Do not tighten it all the way yet. Leave it loose, with
about 5 mm left to tighten.
Speakers Mounting Screw
(M5 × 10 mm)
Leave a space of about 5 mm
Speakers Mounting
Screw (M4 × 10 mm)
Speaker R
Speaker L
Top, Back of
Display
5 mm
3. Hang the speaker mounting bracket on the screw
you installed at the top by passing the wide part
over it and lowering into the slot; screw in the
lower screw temporarily.
After passing the wide part of the hole of the speaker
mounting bracket (top) over the screw, lower the
speaker onto it.
After passing the wide part of the
hole over the screw, lower the
speaker.
Speakers Mounting Screw
(M5 × 10 mm)
4. Adjust the position of the speaker and then fix the
upper and lower screws firmly.
• Adjust the positions of the speakers and the Plasma
Display so their top surfaces are the same height.
• Adjust the positions of the speakers and the Plasma
Display so their side surfaces are parallel.
5. Ti ghten the two screws, at the top and bottom for
each speaker (total of four screws), thus fixing the
speakers to the display.
Speakers Mounting Screw
(M5 × 10 mm)
Speakers Mounting Screw
(M5 × 10 mm)
English
Tighten the bottom speaker
mounting bracket to the display
temporarily (one place bottom).
3