Boiling Water; Descaling The Kettle - Dometic Waeco PerfectKitchen MCK750 Notice D'utilisation

MCK750
7.2

Boiling water

➤
Set down the water tank in a central position on the locking tongues (fig. 3 1,
page 2).
➤
Turn the water tank 90° anti-clockwise.
The lock (fig. 3 2, page 2) must engage audibly.
➤
Press the two locking buttons in the lid (fig. 4 2, page 3) together and open the
lid.
➤
Pour the desired amount of water into the tank.
➤
Close the lid.
✓
The lid engages audibly.
➤
Check that the voltage specification on the type plate corresponds to that of the
energy supply.
➤
Connect the DC plug to a DC socket.
➤
Press the On/Off switch (fig. 1 3, page 2) to start the boiling procedure.
✓
The control lamp (fig. 1 4, page 2) is lit up during the boiling procedure.
✓
The kettle is automatically switched off when the water boils.
You cannot switch off the kettle by hand.
➤
To remove it, press the lock (fig. 5 1, page 3) and turn the water tank 90° clock-
wise.
7.3

Descaling the kettle

To ensure quick heating and extend the service life of the heater coil, the kettle has
to be descaled after boiling approx. 30 – 40 times. Noticeable signs that descaling is
necessary are:
Prolonged boiling time.

 Loud boiling noises,
 Visible deposits on the base.
NOTICE!
A
For health and ecological reasons, use only biological means of descaling.
Purchase these means only in specialist stores.
Do not under any circumstance use hydrochloric or sulphuric acid for
descaling.
NOTE
I
Observe the application and dosing recommendations of the manufacturer
of the decalcifier.
EN
Using the kettle
15