SATA jet 5000 B Mode D'emploi page 508

Operating instructions SATAjet 5000 B RP/HVLP (DIGITAL)
US
9.1. Replacing the Nozzle Set
and [7-6]
Every SATA nozzle set consists of "paint needle" [7-1], "air cap" [7-2]
and "fluid tip" [7-3] and has been hand-adjusted to provide a perfect
spray pattern. Lubricate both paint needle [7-1] in the paint needle area
(approx. 3 cm before the needle sleeve, paint needle spring) and material
flow control screw [1-11]. Therefore, always exchange the complete noz-
zle set. After installation, please adjust material flow according to chapter
7.2.
9.2. Replacing the Air Distribution
2], [7-3], [8-1], [8-2] [8-3], [7-4], [7-5] and [7-6]
• Remove air distribution ring with SATA extraction tool only.
• Do not apply force to avoid damage of sealing surfaces.
Check sealing surfaces inside the spray gun [8-2] after disassembly,
clean them, if required. Should the sealing surfaces be damaged,
please contact your SATA dealer. Align new air distribution ring with the
help of the marking [8-3], (pin must be located in the drilling) and press
in with even force. Adjust material flow according to chapter 7.2 after
installation.
9.3. Replacing the Paint Needle Sealing Steps:
1], [9-2] and [9-3]
When paint material leaks from the self-tensioning paint needle packing,
it needs to be replaced. Remove trigger according to [9.2]. After disas-
sembly, check if the paint needle is damaged or replace the nozzle set, if
required. Make sure that trigger sleeve [9-2] is in correct position when
trigger is reassembled. Adjust material flow according to chapter 7.2 after
installation.
508
Notice!
Information!
[7-1], [7-2], [7-3], [7-4], [7-5]
Ring Steps: [7-1], [7-
[9-