Replacing The Filters - Sage FoodCycler Guide Rapide

4. The Cooling cycle (green light) is the last
cycle before completion. The Cooling
mode lasts under 30 minutes.
5. The Change Filter light (red) will illuminate
when it is time to replace the filters.
NOTE
Typical processing time takes an average of
4 - 6 hours. Cycle time will vary depending
on the types of food being processed and
the total moisture content. Total maximum
processing time is 8 hours. The cooling
phase takes up to an additional 30 minutes.

REPLACING THE FILTERS

Your EcoFilters should be replaced regularly
or as indicated to ensure an odourless cycle.
If the FoodCycler is used regularly, the filters
will need to be changed every 3-4 months
(500 Hours).
At the end of this period, the Change Filter
light will illuminate red indicating that the
filters need to be replaced.
• Remove all packaging from the EcoFilters
and Filter Air Guides before first use.
Remove all packaging from replacement
filters before fitting into the FoodCycler.
Follow the steps described below.
CHANGE
FILTER
COOLING
GRINDING
DRYING
NOTE
Always change both filters at the same time.
IMPORTANT
The filters are not washable. Do not immerse
any part of the filters in water as it will cause
damage.
To replace the EcoFilters:
1. Open the back panel of the FoodCycler
by pressing down on the plastic tab at the
top of the panel (with the arrow), then pull
outwards to release. Remove the two filter
air guides sitting on top of the filters by
tilting slightly towards you, then lift them up
and out of the FoodCycler. Do not discard
the filter air guides.
2. Keeping the used filters straight, twist
each of them counter-clockwise to
remove from the filter cavities. Remove
one at a time.
17