TLS M 100 Série Mode D'emploi page 27

Operation manual
PROG (Track programming)
Press the PROGRAM button to start the track programme function.
Press the UP and DOWN buttons to select a previous or next track
until the selected track is displayed in the LCD.
Press the PROGRAM button to confirm the track programming.
Repeat steps 2 and 3 to programme any further tracks. Press the
PLAY button to start the playback in the selected programme order.
A maximum of 21 tracks can be programmed.
REMAIN (Remaining time)
The display shows the elapsed playback time of a track. Press the
REMAIN button to access two more time functions.
Press the REMAIN button to view the remaining playing time of the
track.
Press the REMAIN button again to view the total remaining
playback time on the CD.
This function is not available during track programming, random
selection or repeat.
A ⇔ ⇔B (Programmed repeat function) ⇔ ⇔
This function repeats a part of a track as often as required.
Press the A B button at the beginning of the required extract.
⇔ ⇔
⇔ ⇔
Press the A
⇔ ⇔ ⇔ ⇔
player now runs in a repeat loop between the selected points.
Press the A B button again to end the selected repeat section.
⇔ ⇔ ⇔ ⇔
Infrared remote control
Use the infrared remote control to operate all the CD player functions
on the TLS device (see Figure 4). The functions on the remote control
buttons correspond to those on the operation buttons of the CD player.
The remote control has a few additional functions.
Status 11/03
B button at the end of the required extract. The CD
27