Favero Electronics FTT-1 Mode D'emploi page 4

TEST OF THE WEAPON WITH THE BODY CORD
After configuring FFT-1 with the TESTER function, insert
the 3-pin plug connecter of the body cord to FTT-1 and
then, according to the weapon connected to the other end
of the body cord, perform the following tests to check
whether the lights work properly.
EPEE test with BODY CORD
FOIL test with BODY CORD
SABER test with the BODY CORD
lights
If the tip is not pressed, both the
red green
lights should be turned off.
Pressing the
should turn on.
Touching the guard or the blade
with the FTT clip, the red light
should turn on.
lights
If the
red green
light should turn on.
Pressing the
should be turned off.
When the FTT clip is nipped, the
green light should turn on, whilst
the red light turns on if the point is
not pressed.
lights
The red light must always remain
red green
on.
When the FTT clip is nipped, the
green light should also turn on.
- 4 -
tip , the green light
tip is not pressed, the red
tip , both lights
ENGLISH