Samsung FlexWash WV60M9900A Série Manuel D'utilisation page 28

Installation
28 English
FlexWash_WV9900M_DC68-03768A-04_EN.indd 28
To connect the water hoses to the taps:
1. Connect one end of each water hose to
the Hot or Cold tap.
2. Turn the fittings by hand until they
are tight, and then tighten them an
additional two-thirds of a turn with
a pliers. To prevent damage, do not
overtighten the fittings.
3. When done, pull the water hoses up
and down to check if they are properly
connected.
4. Put the other ends of the hoses into
a bucket and open the taps for 10-15
seconds to remove impurities. When
done, close the taps.
2017-05-22 7:03:29