Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Table of settings
If the control system fails unexpectedly, all of the settings should be reset for initial configuration.
In this case, problems are inevitable if all of the setting values are entered in the following table. If
there are questions, this table has to be provided. Only then is a simulation possible to reproduce
the error.
Basic functions:
Program version........
Program diagram......
Program number PR..
Basic parameters PAR:
Linking of output LO.... _____ / ex = OFF
Priority assignm. PA...
max1 off.....................
max2 off.....................
max3 off.....................
min1 on...................
min2 on...................
min3 on...................
diff1 on.......................
diff2 on.......................
diff3 on.......................
Subject to change without notice
_____
_____
_____ / ex = 0
_____ / ex = OFF
_____°C / ex = 75°C
_____°C / ex = 75°C
_____°C / ex = 75°C
_____°C / ex
= 5°C
_____°C / ex = 5°C
_____°C / ex = 5°C
_____ K / ex = 8K
_____ K / ex = 8K
_____ K / ex = 8K
ex = factory settings
max1 on............... _____°C / ex = 70°C
max2 on..............
max3 on..............
min1 off...............
min2 off...............
min3 off...............
diff1 off................
diff2 off................
diff3 off................
_____°C / ex = 70°C
_____°C / ex = 70°C
_____°C / ex = 0°C
_____°C / ex
= 0°C
_____°C / ex
= 0°C
_____ K / ex
= 4K
_____ K / ex
= 4K
_____ K / ex
= 4K
English
2016
35
Publicité
Table des Matières
