Storage; Faults - NORDFOREST Titan 80 Mode D'emploi

Storage

Fault
The ratchet can no longer be
turned
Loud roller bearing noises
Lifting wedge no longer
pushes forward
56 Nordforest Mechanical Titan 80 Felling Wedge
Storage
›
Only store the Nordforest Titan 80 Mechanical Felling Wedge in
closed rooms.
›
Make sure the storage room is well ventilated and dry.
›
Use the original packaging of the Nordforest Titan 80 Mechanical
Felling Wedge. If you temporarily store the Nordforest Titan 80
Mechanical Felling Wedge in its original packaging, protect it from
damage due to dirt, dust or moisture.

Faults

If you are not able yourself to repair the Nordforest Titan 80 Mechanical
Felling Wedge, contact your dealer or an authorised repair workshop.
Before you contact your dealer, an authorised repair workshop
i
or the manufacturer, please not the specifications and the tool
number on the type plate. The details are required for rectifying
the problem or ordering spares.
The possible faults, causes and remedies are listed in the table below.
The safety regulations must be observed for all cleaning, maintenance
and repair work.
Cause
The full extension length
of the lifting wedge is not
reached
tapered roller bearing
defective
tapered roller bearing
defective
Shaft drive defective
Spring steel plates bent
Remedy
Turn the ratchet clockwise
Contact manufacturer to
remedy fault
Contact manufacturer to
remedy fault
Contact manufacturer to
remedy fault
20-076 | 03.2017