Makita DCL182 Manuel D'instruction page 8

Cleaning (Suction)
Nozzle
Attach the nozzle to clean off tables, desks, furniture, etc.
Nozzle slips on easily.
1
011544
Nozzle + Extension wand (Straight pipe)
The extension wand fits in between the nozzle and the
cleaner itself. This arrangement is convenient for
cleaning a floor while standing erect.
3
2
011545
Corner nozzle
Fit on the corner nozzle for cleaning corners and crevices
of a car or furniture.
2
011546
Corner nozzle +Extension wand (Straight pipe)
In tight quarters where the cleaner itself cannot squeeze
in, or in high places hard to reach, use this arrangement.
3
011547
1. Nozzle
1. Cleaner body
1
2. Extension wand
3. Nozzle
1. Cleaner body
2. Corner nozzle
1
1. Cleaner body
2. Extension wand
3. Corner nozzle
1
2
Cleaning without nozzle
You can pick up powder and dust without nozzle.
011565
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off before
•
attempting to perform inspection or maintenance.
After use
NOTE:
Putting the cleaner against the wall without any
•
other support cause the cleaner to fall down and be
damaged.
011549
Cleaning
011550
From time to time wipe off the outside (cleaner body) of
the cleaner using a cloth dampened in soapy water.
Clean out also the suction opening, dust bag/dust pack
mounting area and the dust stopper.
CAUTION:
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
8